ACG-7 PULSE GENERATOR

The ACG-7 generates a positive, fast risetime pulse for general diagnostics and calibration of wideband data transmission systems. The output pulse into 50 ohms exhibits 10V ±5% amplitude, nominal 50 ns width, and ~1 ns risetime.

The ACG-7 is battery powered and may be operated in repetitive, manual, or external trigger modes. In the repetitive mode, the pulser free runs at approximately 1 kHz. A trigger output is available for sync to external equipment. IN the manual mode, one pulse is generated each time the manual pushbutton is depressed. The trigger output is also available in this mode. For external trigger, a positive pulse of 5V into 50 ohms should be applied to the trigger in/out port. The maximum repetition rate for external trigger is approximately 1 kHz.

The ACG-7 is powered by two 7.2 volt, 225 MAH nickel cadmium (NICAD) batteries and requires a charger or power supply with 16 to 18 volts, 25 mA minimum output for charging.

Data Specification Sheet